Guidelines for Applying Grip Tape to a Scooter

Maintain control of your pro scooter by using a fresh piece of grip tape. You can apply grip tape independently, but there are a series of steps you must follow. Our scooter specialist, Mike, is ready to guide you through this task:

1. Begin by taking measurements of both your deck and grip tape.
2. Turn over the grip tape to mark your dimensions.
3. Cut the grip tape with a ruler and a sharp knife.
4. At this point, detach the brake, axle, and deck ends.
5. Peel the adhesive backing from the grip tape and position it on the deck.
6. Ensure it's aligned correctly and then adhere it to the deck.
7. With the help of the protective paper, push out any air bubbles.
8. Cut two small slits in the grip tape at the end of the deck.
9. Score the edges of the deck to trim the grip tape accordingly.
10. Using a sharp knife, execute a long, straight cut along the deck's sides.
11. Carefully proceed around the back of the deck.
12. If necessary, adjust any rough edges.

Congratulations, your grip tape is now perfectly applied!